Servo-hydraulic tensile testing machine Instron series DX

a Series of test systems InstronDXявляется convenient and economical solution for the modern quality control laboratories, when continually required to carry out tensile tests and bending/compression on one machine. Data of the test machine have two working areas - one in tension, the other compression/bending. In this case the operator does not need to constantly move heavy fixtures and the machine is always ready for two different tests. Tensile testing machine series InstronDXявляются a good tool for testing metal samples, fittings, fasteners, concrete, etc. for tension, compression and bending with forces of up to 1500 kN (150000 kgf).

Integrated into the base frame hydraulic unit (on models with a load capacity up to 600кН) allows to save area of the laboratory and to operate more pieces of equipment in the room. And the presence of external multi-function control panel makes system InstronDXотличным solution for routine, standard work in production, while maintaining the highest accuracy characteristics.  

the

the
• measuring Range of load 1:500 (i.e., a torque sensor is used from 0.2% to 100% of its nominal value without loss of precision)

the

• measurement Accuracy load 0.5% of measured values

the

• Frequency synchronous recording of data 1 kHz

the

• power 220V, 1 phase, 50 Hz or 380V, 3 phases, 50 Hz (for models 1000HDXи 1500HDX)

the

• Full software control

the

• Availability of multi-language multi-function control panel

the

• Automatic detection of connected sensors verification time of the last calibration

the

• possible tests of tensile and bending/compression without reinstalling fixtures

the

• Modern, Russified software Bluehill3

the

• Certificate of entry in the State register of measuring instruments

specifications

the

the

the

the

the

these systems are equipped directly for the needs of the customer, they can be made with a larger test area in height or is made in a configuration with one zone for testing only in compression/bending.

For more technical information, as well as data about the systems on the warehouse in Moscow, please contact the specialists of the division of materials testing by phone +7 (495) 150-07-85.